Horizontal Air compressor tank replacement for storage and distribution chlorine , propane
1. The important of air compressor tank play in air compressor system :
Air compressor tank is an integral and important part of any compressed air system. Typically a receiver tank is sized at 6-10 times the flow rate of the system. So, if a compressor has a rating of 25 cfm at 100 psi, the receiver tank should be 150 cubic feet, minimum. In a compressed air system, a receiver tank provides the following benefits:
- Air compressor tank acts as a reservoir of compressed air for peak demands.
- Air compressor tank will help remove water from the system by allowing the air a chance to cool.
- Air compressor tank minimizes pulsation in the system caused by a reciprocating compressor or a cyclic process downstream.
Much like a water reservoir provides water during times of drought and stores water during the wet times, an air receiver tank compensates for peak demand and helps balance the supply of the compressor with the demand of the system.
Receiver tanks are required by law to have a pressure relief valve and a pressure gauge. The relief valve should be set to 10% higher than the working pressure of the system.
2. Company Advantages
| 1 | free artwork service for confirmation before production |
| 2 | OEM/ODM Service offered. |
| 3 | Low MOQ |
| 4 | 25 years manufacturing experience,good quality assurance. |
| 5 | ASME certificate approved, high quality. |
| 6 | Factory supply directly will help you save much money. |
| 7 | Fast delivery as we always have 6000 pieces in stock. |
3. Product specifications:
| 1.Brand | Shenjiang |
| 2.Name | 30000 liter horizontal air compressor tank |
| 3.Capacity | 30000 liter |
| 4.Diameter | 2500 mm |
| 5. Size | 2500*2500*6982mm |
| 6.Package | Standard wooden packing |
| 7.Pressure | 1.6 Mpa |
| 8.Connector | Thread and flange for choice |
| 9.ASME | ASME .CE.GB150 |
4. Our production process
1. Lofting, marking-off & cutting.
2. Manufacturing & welding
a. Make holes
b. Crimping plate
c. Spheronization
d. Welding
e. Install
f. Circumferential welding
3. Surface treatment
a. For Carbon Steel (1)Sand blasting (2)Primer (for 2 times) (3)Finishing coat
b. For Stainless steel (1)Sand blasting OR (2) Polishing
